ICF10B

Fig. 1: Interface elements along the crack plane. (a) Shows the artificial overlap between interface elements and surrounding elements. (b) A corresponding configuration with no overlap. a background element with the non–zero initial width w0 . Fig. 1a illustrates the finite element mesh near the line of symmetry, with the background interface element sketched in, while Fig. 1b indicates the configuration if this interface element is attached to the surrounding elements as a common element. The displacement components un and ut on the top side of the interface element (Fig. 1a) are required to be compatible with the displacements on the edge of the adjacent finite element. Then with the assumption that the displacements inside the interface element vary linearly through the element width (in the x2–direction), the displacement gradients inside the element are u1 x1 ut x1 , u2 x2 2un w0 , u1 x2 0 (1) Furthermore, when choosing to replace displacement gradients by their averages through the element width, we find u2 x 1 0 . From these displacement gradients it is possible to determine the current metric tensor Gij , the Lagrangian strain tensor ij and its increment · ij in any point on the middle surface, x 2 0 , of the interface element. Thus the evolution of stresses and of damage inside the interface can be calculated from a set of constitutive relations. These constitutive relations are based on the modified Gurson model [4,5] , which makes use of an approximate yield condition for a porous solid 2 e 2 M 2q1f *cosh k k 2 M 1 q1f * 2 0 (2) where e (3s ijs ij 2)1 2 and sij ij Gij k k 3 . The void volume fraction is f , and f*(f) is a function that approximately describes final failure by void coalescence. The change of the void volume fraction during an increment of deformation is taken to be given by f · (1 f)Gij · P ij · M · k k 3 (3) where the first term results from the growth of existing voids, and the two last terms model the increment due to nucleation [6] . The numerical solutions are obtained by a linear incremental finite element method, based on the incremental principle of virtual work, with the material outside the interface represented by finite strain J2 flow theory. The details of the computational method are given in [3] and shall not be repeated here. As described in [3] , an extra parameter r0 is introduced, to be able to reduce the tangential components of the nodal forces calculated by the interface element procedure described above. Thus, if Pt elm denotes the interface element contribution to the value of the nodal force component tangential to the interface, as calculated by the interface element procedure, the tangential component Pt actually applied in the solution is taken to be given by Pt r0 Pt elm (4)

RkJQdWJsaXNoZXIy MjM0NDE=