Here, r0 0 will be used, as this gives the best representation of an initially sharp crack (see further discussion in [3]). The value of the initial width w0 of the strip (Fig. 1) is non–zero, representing approximately 0.7 times the initial void spacing. In the small–scale yielding solution for crack growth, the value of the J–integral is calculated on a number of contours around the crack–tip to check agreement with the prescribed amplitude K of the edge displacements (i.e. K2 JE (1 2)) , and very good agreement is found. For the presentation of the results reference values for the J–integral and for the corresponding size of the plastic zone are defined J0 yw0 , R0 1 3 K0 y 2 (5) where the value K0 corresponds to J0 . According to the small strain linear elastic solution the in–plane stress components near the crack–tip are of the form K 2 r f ( ) T 1 1 (6) where r , are polar coordinates, ij is Kronecker’s delta and T is a non–singular stress term, acting parallel to the crack plane. In the present analyses the T–stress is applied first, together with the corresponding transverse stress 33 T under plane strain conditions. RESULTS The elastic–plastic material parameters in the first case analysed are specified by y E 0.002 and 0.3 with the power hardening exponent N = 0.2 . Furthermore, in the porous ductile material model the initial void volume fraction is fI 0.01 , and other parameter values in the model are q1 1.25 , fC 0.15 and fF 0.25 . Fig. 2 shows predicted crack growth resistance curves for various values of the T–stress according to (6) . It is well knows from other fracture models, e.g. [7] , that positive values of T tend to have little effect on the fracture toughness, while negative values of T tend to increase the toughness. Therefore, Fig. 2 uses the curve for T = 0 as reference. The other three curves show that also the present interface model for ductile fracture predicts increasing fracture toughness for increasing negative values of T. In Fig. 3 the level of strain hardening is lower, N = 0.1 , but otherwise all material parameters are identical to those considered in the previous figure. It is seen that also here the negative T–stresses give a significant increase of the fracture toughness, in fact a relatively much larger increase than that found in Fig. 2. This in qualitative agreement with predictions of a more standard cohesive zone model [7] , where it was also found that the T–stress effect is stronger for the more low hardening material. 0.75 0.50 0.25 T y 0.0 J J0 a w0 Fig. 2: Crack growth resistance curves for various values of the T–stress, when fI 0.01 , N 0.2 and ro 0 .
RkJQdWJsaXNoZXIy MjM0NDE=