ICF10B

Oral/Poster Reference: ICF108920R Embrittlement of High Strength b-Ti Alloys R.P. Gangloff Department of Materials Science and Engineering, University of Virginia, SEAS-Thornton Hall, Charlottesville, VA 22903-2442, USA ABSTRACT The outstanding strength of a-precipitation hardened b-Ti alloys is compromised by low plane strain fracture toughness, hydrogen embrittlement and perhaps elemental segregation. Solution treated all-b alloys are immune to hydrogen cracking for low to moderate H concentrations, but critical aging to form a triggers transgranular internal hydrogen embrittlement (TG IHE, along a/b interfaces) and intergranular hydrogen environment embrittlement (IG HEE, along b-grain boundaries). Increased strength does not explain this deleterious effect of aging. Rather, the aging dependence of TG IHE appears to be related to H enrichment in b and microscopic stress intensification at a/b interfaces arrayed continuously through b grains. Intergranular HEE is not explained by either grain boundary a formation or deformation localization due to aging. HEE persists when all a is dissolved, suggesting that elemental segregation of Si or impurities may be the requisite for IG cracking, but the offending species have not been resolved. KEYWORDS Titanium alloys, fracture toughness, hydrogen embrittlement, fracture mechanics, embrittlement. INTRODUCTION Titanium alloys based on a bcc (b) matrix that is hardened by fine precipitates of the hcp-a phase exhibit high strength to weight, excellent formability, and hardenability properties that enable high performance aerospace, marine, and land-based applications [1,2]. For example, a martensitic alloy steel must exhibit a tensile yield strength (sYS) of about 2400 MPa to exceed the strength-to-density ratio of the strongest b-Ti alloys (sYS ~ 1600 MPa). Results suggest, however, that fracture toughness and resistance to hydrogen (H)-assisted cracking are degraded substantially in concert with a strengthening of metastable b. The objective of this work is to examine the effect of a formation on the fracture resistance of modern b/a-Ti alloys, emphasizing deleterious hydrogen embrittlement and the crack tip damage mechanisms that govern damage tolerant properties. EXPERIMENTAL PROCEDURES Several b-Ti alloys were examined, including Ti-15-3 (Ti-15V-3Cr-3Sn-3Al in weight pct) [3-5], LCB (Low Cost Beta, Ti-7Mo-4.5Fe-1.5Al) [3], Beta-21S (Ti-15Mo-3Nb-3Al) [4,6], and Beta-C (Ti-8V-6Cr-4Mo-4Zr-3Al) [6-8]. Each alloy contained a total-dissolved H content of CH = 25-200 ppm (parts-per-million by weight). High strength microstructures were developed by solution treatment (ST) above the b transus, air cooling to retain b only, and heating isothermally to precipitate a. This solution treated and aged (STA) microstructure is shown in Figure 1 for Ti15-3 sheet where up to 60-volume pct of sub-micrometer a needles precipitate in the Burger’s orientation of { } { } a b a b 1120 0001 , 111 110 2 2 [9]. In addition to a, (Ti,Zr)5Si3 can precipitate at high aging temperatures and w may be produced at low aging temperatures [9,10].

RkJQdWJsaXNoZXIy MjM0NDE=