ICF10B

TABLE 4 NORMALIZED MAXIMUM TENSILE STRESSES ómaxI AND ómaxII AND LOCATION s’maxI OF ómaxI Material Moduli [MPa] Iosipescu Mode ómax /ôs s’maxI ómaxII/ôs EP ET Virgin SIRCA 380 67 Transverse 2.344 0.024 1.691 Virgin SIRCA 130 34 Transverse 2.171 0.024 1.544 Charred SIRCA 630 170 Transverse 2.146 0.024 1.529 Charred SIRCA 138 89 Transverse 1.694 0.029 1.297 Virgin PICA 143 12 Transverse 2.633 0.024 2.072 Charred PICA 107 33 Transverse 2.082 0.024 1.485 Virgin SIRCA 380 67 Parallel 1.558 0.162 2.195 Virgin SIRCA 130 34 Parallel 1.584 0.149 2.394 Charred SIRCA 630 170 Parallel 1.584 0.147 2.367 Charred SIRCA 138 89 Parallel 1.531 0.117 1.633 Virgin PICA 143 12 Parallel 1.535 0.176 1.913 Charred PICA 107 33 Parallel 1.588 0.147 2.274 CONCLUSIONS Iosipescu shear tests were conducted on composite LCA materials, under parallel and transverse loading conditions, and the experiments were modeled with anisotropic, linear elastic, FEA. The maximum nominal shear stress was measured, although the observed fracture patterns and FEA results indicated that the materials failed in a tensile mode rather than by shearing. The maximum values of principal stress in FEA occurred in regions where fracturing was observed in the experiments. The shear stress distribution along the notched cross-section was also computed. ACKNOWLEDGEMENTS NASA Ames Grant #NCC2-1049 provided financial support for this work. S. Nagasawa was an Overseas Research Scholar of the Japan Ministry of Education, Science and Culture, on leave from Nagaoka University of Technology. Support from K. Fields, C. Johnson, H. Tran, and D. Rasky is gratefully acknowledged. REFERENCES 1. Tran, H.K. (1994). NASA TM 108798. 2. Iosipescu, N. (1963). Rev. Mec. Appl. 1, 147. 3. Adams, D.F. and Walrath, D.E. (1986). Experimental Mechanics. 27(2), 113. 4. Daniel, I.M. and Ishai, O. (1994). Eng. Mechanics of Composite Materials. Oxford Univ. Press. 5. Parmenter, K.E., Shuman, K., Milstein, F., Johnson, C.E., Tran, H.K. and Rasky, D.J. (2001). Journal of Spacecraft and Rockets. 38(2), in press. 6. Adams, D.F. and Walrath, D.E. (1987). Journal of Composite Materials. 21, 494. 7. Chiang, Y.J. (1996). Journal of Testing and Evaluation, ASTM. 24(1), 1.

RkJQdWJsaXNoZXIy MjM0NDE=