ORAL/POSTER REFERENCE: ICF1001064 EXPERIMENTAL INVESTIGATION OF THE INERTIAL EFFECTS OCCURRING IN IMPACT TESTS ON PLASTICS WITH VARYING MASS DISTRIBUTION A. Pavan1 and G. Barbaglia1 1Dipartimento di Chimica Industriale e Ingegneria Chimica ‘G. Natta’, Politecnico di Milano, Italy ABSTRACT Aim of the work is to elucidate some aspects of the phenomenology of impact tests in order to improve previously proposed modelizations. The experimental investigation focused on the influence of specimen dimensions and specimen mass distribution on the inertial effects observed in the initial part of an impact test. The experiments were carried out on single-edge notched specimens in the “one-point bending” mode. The flexural compliance of the notched specimens was varied by varying notch depth and specimen length and their mass distribution was varied by varying their length and by adding some concentrated masses. Analysis of the load-time traces recorded by the instrumented tup of the striker impacting the specimen at 1 m/s shows the distinct role played by the “contact mass” involved in the very first instants of the impact process, and by the inertia of the specimen wings. The “dynamic” one-point bend compliance of the specimen appears to be proportional to its “static” three-point bend compliance, if the specimen length in the former bending mode is equated to the span between the anvils in the latter bending mode. These results gave hints to the improvement of a previously proposed ‘analogical’ model for simulating the dynamics of the impact test. KEYWORDS Instrumented impact test, One-point bending, Inertial effects, Impact fracture, High rate of loading INTRODUCTION Use of instrumented impact testers is becoming commonplace and acquisition of the load vs. time response from a pre-cracked specimen makes the test amenable to fracture mechanics analysis, thus allowing an (intrinsic) value of fracture toughness to be extracted from the experimental data. The analysis of the force-time trace recorded in an impact test, however, is complicated by the dynamic effects occurring when the test piece is loaded rapidly. Even at moderately high loading rates (speeds of the order of 1 m/s) the inertial forces set up by the accelerating masses produce effects that may mask the true
RkJQdWJsaXNoZXIy MjM0NDE=