following steps: • SEM-in situ experiments on 3-point bending of specimens with inclined notches, • FE-Simulation of the deformation of the specimens on macro- and mesolevel, taking into account the real microstructure of the steels observed in the SEM-experiments. The SEM in-situ observation of the damage initiation allowed to clarify the micromechanisms of damage initiation, whereas the developed hierarchical finite element model (macro- and mesomodel) made it possible to determine the failure conditions for steels constitutents using the real loading conditions and real microstructure of the steel. SEM IN-SITU INVESTIGATIONS OF MICROMECHANISMS OF DAMAGE INITIATION Conditions of Experiments In order to clarify the mechanisms of damage initiation and growth in the steels, a series of SEM-in-situ-experiments was carried out. 3-point bending specimens with an inclined notch, as described in [4], were used in these tests. These specimens allow to observe the micro- and mesoprocesses of local deformation and failure of carbides and the matrix of steels during loading of macroscopic specimens in the SEM. The shape and sizes of the specimens are shown schematically in Figure 1. The advantage of the specimen with the inclined notch is that the most probable location of first microcrack initiation in the specimen notch can be simply predicted (which is not the case for the usual 3-point bending specimens). Therefore, one can observe this place with high magnification during loading and identify the load and the point in time at which the first microcracks form very exactly. Specimens made from the cold work steel X155CrVMo12-1 (in further text denoted as KA) and high speed steel HS6-52 (denoted as HS) have been used. In the experiments, the specimens with different orientations of primary carbide layers were studied. Since the tool steels are produced in the form of round samples and was subject to hot reduction after austenitization and quenching, they are anisotropic: the carbide layers are oriented typically along the axis of the cylinder (this is the direction of hot reduction). Therefore, the following designation of the specimen orientation was used: L – the direction along the carbide layers, R – radial direction in the workpiece, C – the direction along the workpiece axis. In the experiments, specimens with orientations CL, LC and CR have been used. The CR and CL specimens are shown in Figure 2. The specimens have been subjected to the heat treatment (hardening at 1070oC in vacuum and tempering 2 times at 510oC), and then polished with the use of the diamond pastes of different sizes till the roughness Rz of the surface of the specimens does not exceed 3 µm. The notch region of the specimens was etched with 3 % and 10 % HNO3 until the carbides were seen on the surface. Then, the specimens have been subjected to loading with simultaneous observation of the notch region in SEM. The scheme of loading is given in Figure 1 as well. Each loading test was repeated 3 times for each type of steel and specimen orientation. 2
RkJQdWJsaXNoZXIy MjM0NDE=