ICF10B

FAILURE STRESS OF PRIMARY CARBIDES Figure 4 gives the distribution of von Mises stress in the real microstructure of the cold work steel at the loads at which the carbide failed. Supposing that failure of the carbides is determined by the action of maximal normal stresses, one obtains the failure stresses of carbides for different steels and orientations (see Table 2). TABLE 2. FAILURE STRESS OF CARBIDES Type of the steel KALC KACR HSCR HSLC Failure stress of carbides, MPa 1826 1840 1604 2520 It is of interest to compare the above results with some literature data. Lippmann et al. [8] and Lippmann [4] obtained the values 1863...1987 and 1200...2100 MPa, respectively, for the failure stress of carbides in cold work and high speed steels. One can see that our values for cold work steels are very close to those given in [4]; the values for high speed steels are about the higher boundary of the variation range. Figure 4. Von Mises stress distribution in the real microstructure of the steel in the notch of the specimen. CONCLUSIONS On the basis of the above analysis, one can draw the following conclusions: 1) The course of failure of the specimens was as follows: formation of one microcrack at some carbide, then formation of several microcracks at many carbides in different places of the observed area (in so doing, the microcracks are formed rather at larger carbides at some distance from the boundary of the specimen, than in more strained macroscopically 5

RkJQdWJsaXNoZXIy MjM0NDE=