The first-stage blading is illustrated in Fig. 1. As shown, a large number of cooling holes has been manufactured into the surface of blades and vanes, where cooling air will be discharged. Figure 1: Blade and vane stage 1 with film cooling holes The first stage turbine blades operate at high gas temperatures. There is a pronounced temperature gradient between outside and inside of blade walls due to an indispensable intensive cooling. This temperature difference will cause high thermal stresses. Additionally, the centrifugal force has also to be considered for the blade design. The life prediction procedure for components with stress concentration can be carried out using the local approach concept, [4-5]. The applied material design curve is usually determined with standard cylindrical smooth samples under consideration of materials data scatter. However, for a reliable life prediction, not only the maximum local stress and strain is to be determined by elastic-plastic FEcalculations. Inhomogeneous stress states, manufacturing processes and surface quality should also be taken into account. In order to verify the local approach concept and to insure the long-term operational reliability of the SC blades in land based gas turbines for power generation, special LCF test specimen with holes on the gauge length has been used to determinate the life time and to investigate the crack behaviour under fatigue loading close to the operation conditions. EXPERIMENTAL DETAILS Fig. 2 shows the shape of the LCF-specimen. Holes were drilled by laser using the same tolerances and operating parameters as in blade manufacturing. The thickness of the specimens was similar to the wall of the blades. Figure 2: Special LCF test specimen with illustration of secondary orientation of 0° and 45° A A A A 001* 010* 100* A – A: 0°* 45°
RkJQdWJsaXNoZXIy MjM0NDE=