ICF10B

In Fig. 4 the relaxation behaviour of 2 specimens cycled under the same strain range, but one of them with a holdtime, is compared. The holdtime at the maximum tensile stress caused a much stronger relaxation of the mean stress, which became negative after only 20% of the lifetime. The specimen without holdtime had a high positive mean stress and only about a third of lifetime compared to that one with holdtime. Figure 4: Example of mean stress development at 700 °C The stress concentrations at the holes have been calculated with finite elements under the assumption of linear elastic material behaviour with cubic symmetry, see Fig. 5. Only the part of the test specimen between the extensometer has been modelled. Constant displacements have been applied to the corresponding cross sections between the extensometer to simulate the strain controlled LCF-test. The displacement is directly proportional to the nominal strain over the gauge length. The specimen is horizontally symmetrical with an additional axis of symmetry. Therefore, only one quarter of the specimen was modelled. Highest stresses are found along the curve where the holes intersect the outer surface of the specimen. Figure 5: FEM-calculation of local stress With the help of the FE-model the maximum local stresses were calculated as a function of nominal strain. Based on these results the maximum local total strain (with elastic and inelastic parts) is estimated with Neuber´s rule [6-8]. The cyclic stress-strain curve is used to take plastic deformations into account. From this the relation between the nominal strain over the gauge length and the local strain is derived. 0,2 0,4 0,6 0,8 1,0 -100 0 100 200 300 400 N/Nf max σm in MPa Sample without holdtime Sample with 20 min. holdtime Axis of Symmetry Symmetric Boundary Conditions Axis of Specimen Displacements

RkJQdWJsaXNoZXIy MjM0NDE=