ICF10B

S-N curves for specimens with holes at 900°C and 700°C test temperature, which are based on the local strain and compared with the normalised design curve, are presented in Fig. 6. In both cases the design curve under-estimates the cycles to failure so that a conservative, reliable life prediction using the local approach concept can be expected for the loading conditions considered here. Figure 6: Comparison of results from cooling hole samples with design curve In Fig. 7 results of an equiaxed conventional cast superalloy are compared with that of PWA 1483 SC. The PWA 1483 SC is generally better than the equiaxed material. Even with holes the integral strange range of SC-specimens is higher than that of the equiaxed samples for the same failure cycles. The application of SC-material brings therefore obviously a significant advantage for the gas turbine blades with film cooling holes. However the equiaxed material shows less relative decrease of the integral strange range due to cooling holes. Figure 7: Comparison with a conventional cast superalloy Crack Propagation Metallographical investigations were carried out on samples after the tests. The most tests had more loading cycles than the defined Nf, (5% stress drop). The sample surface with cracks starting at the edges of the holes is shown in Fig. 8 a). The cracks grew perpendicular to the loading direction. After the final loading cycle there were still no direct links of cracks between the holes. One typical example of crack history, happened during an LCF-test, is shown in Fig. 8 b). A crack, initiated by cyclic loading, with a length of more than 0,3 mm on the sample surface could be recorded by the camera system in the fatigue test. After initiation the crack propagation of each crack slowed down while more and more cracks arose, some of them stopped before Nf. The samples were further loaded as usual until the test machine was automatically shut down by its control system. 100 1000 10000 100000 0,05 0,1 1 2 a) T=900°C lg Nf lg Lokal Strange Range normalized Special LCF-samples: without holdtime holdtime Standard samples: design curve 100 1000 10000 100000 0,05 0,1 1 2 b) T=700°C lg Nf lg Local Strain Range normalized 10000 30000 1 2 lg Cycle Number lg Integral Strain Range normalized SC smooth sample SC sample with holes equiaxed smooth sample equiaxed sample with holes

RkJQdWJsaXNoZXIy MjM0NDE=