When Nf had been reached at a 5% stress amplitude drop, all observed cracks were no longer than 1,5 mm and they were still in a stable propagation phase. a) Cracks initiated from cooling holes b) Typical crack initiation and propagation Figure 8: Typical crack development within the hole pattern after LCF-test, As shown the main crack initiated after some other cracks. In this case about 83% lifetime of the specimens was with cracks of more than 0,3 mm. The random distributed micro-cracks due to laserdrilling have obviously no major influence on the total lifetime. CONCLUSIONS A significant improvement of LCF property has been achieved through the application of the single crystal superalloy PWA 1483 SC for gas turbine blades with film cooling holes. The special LCF-fatiguetests using specimens with laser-drilled holes have shown, that: • SC-material can withstand higher strain ranges, even with holes, than an equiaxed material. • Micro-cracks due to laser drilling have no significant influence on the total lifetime. • After initiation the crack propagation of each crack will slow down while cracks at other locations will appear. • With the local strain, determined by FE-Analysis, a conservative and reliable life assessment can be obtained by using the local approach concept. • There won’t be unstable crack propagation before the in design procedure used Nf has been reached. REFERENCES 1. Becker, B., Schulenberg, T. and Termuehlen. H. (1995), The 3A Series Gas Turbines with HBR Combustors, ASME 95-GT-456, Turbo Expo. Houston, Texas 2. Stoloff, N. (1987), Superalloys II, pp. 87-95, Wiley&Sons, New York 3. Wege, R. and Wortmann, J. (1989), Mat.-wiss. Und Werkstofftech. 20, pp. 207-216 4. Seeger, T. and Heuler, P. (1980), Generalized Application of Neuber´s rule, J. Test, Eval. 3, pp. 199-204 5. Savaidis, G., Dankert, M. and Seeger, T. (1995), An Analytical Procedure for Predicting Opening Loads of Cracks at Notches, Fatgue Fract. Engng. Mater. Struct. Vol. 18 No. 4, pp. 425-442 6. Neuber, H. (1961), Theory of Stress Concentration for Shear-Strained Prismatical Bodies with Arbitary Nonlinear Stress-Strain Law, Journal of Applied Mechanics, 12, pp. 544-550 7. Chaudonneret, M. and Chaboche, J. L. (1988), Fatigue Life Prediction of Notched Specimens, Int. Conf. Of Fatigue of Engineering Materials ans Structures, Sheffield 8. Lemaitre, J. (1992), A Course on damage Mechanics, Springer Verlag 0 1 2 3 4 5 0 20000 40000 60000 80000 Cycle Number crack length in mm Nf N0,3mm lifetime with cracks 83% main crack
RkJQdWJsaXNoZXIy MjM0NDE=