ICF10B

REF NO: ICF100236OR FATIGUE BEHAVIOURS OF A COMPRESSOR VALVE STAINLESS STEEL WITH SMALL AMOUNT OF RETAINED AUSTENITE G. Chai1, S. Olsson1,2, P. Liu1, and T. Larsson1,3 1, 2AB Sandvik Steel, 1R&D Centre, 2Strip Division, 811 81 Sandviken, Sweden 3Present address: Outokumpu Copper Partner AB, Copper R&D, 721 88 Västerås, Sweden ABSTRACT Impact and bending fatigue strengths are essential properties for compressor valve steels. The increase in efficiency of compressors requires higher performance valve steels. This paper describes the influence of retained austenite on the fatigue strengths in tension, bending and impact for a modified CrMo martensitic stainless compressor valve steel. It is shown that the impact fatigue strength was significantly improved with increasing retained austenite. The bending fatigue strength was also improved, but reached a maximum value at about 4vol% retained austenite. However, the presence of retained austenite had little influence on the fatigue strength in tension. These different fatigue behaviours were discussed in relation to the microstructures and were interpreted in terms of fracture mechanisms. KEYWORDS Compressor valve steels, CrMo martensitic stainless steels, retained austenite, impact fatigue, bending fatigue, residual stresses, damping capacity, fracture mechanism. INTRODUCTION The change in service condition and increase in compressor efficiency require valve steel with even higher impact fatigue strength. CrMo martensitic stainless steel is a standard compressor valve steel. It usually contains small amount of retained austenite. It was reported that the presence of retained austenite has a positive influence on the impact fatigue properties [1, 2]. In the present study, the influences of retained austenite in a modified CrMo martensitic stainless steel on the fatigue behaviours in tension, bending and impact were systematically investigated. The material used contained much larger amount of retained austenite than the conventional one. Different fracture mechanisms were discussed concerning the different fatigue behaviours observed.

RkJQdWJsaXNoZXIy MjM0NDE=