RESULTS Microstructure Two groups of M23C6 particles were observed: larger ones with a mean size of 0,5µm and dense fine ones with a mean size of 0,1µm (Figure 1). With increasing retained austenite, the number and size of the larger particles were decreased, but those smaller ones were greatly increased (Figure 1a and b). However, the total fraction of M23C6 carbides was decreased (Figure 1c). It was found that the precipitation of these M23C6 carbides obeyed the Nishiyama-Wasserman (N-W) crystallographic orientation relation to martensite. 0 2 4 6 8 10 12 14 16 18 20 0.4 4.4 10.1 14.3 Retained austenite (%) Content of carbides (%) 0.01 0.02 0.03 0.04 0.05 0.06 0.07 0.08 0.09 0.1 Mean size of carbides (µm) content mean size Figure 1: Precipitation of M23C6 in material with (a). 0,4vol% γ’, (b). 14,3vol% γ’; (c). Relation between retained austenite and M23C6 carbides. 5 µm 5 µm M23C6 (c) (a) (b) Another type of precipitate observed was very fine Fe3C particles (with a typical size of 1nm) (Figure 2). It was found that its volume fraction was a function of retained austenite. In the strip with 0,4vol% retained austenite, very few Fe3C particles could be observed (Figure 2a). With increasing retained austenite, the fraction of Fe3C particles was increased (Figure 2b). In the strip with 14,3vol% retained austenite, very dense fine Fe3C particles were observed (Figure2c). One of its crystallographic orientation relationships to martensitic matrix is shown in small picture in Figure 2c, which gives rise to a low energy interface through a low lattice misfit. Figure 2: Precipitation of Fe3C in material with (a). 0,4vol% γ’, (b). 4,4vol% γ’, (c). 14,3vol% γ’, and composite electron diffraction pattern from the zone axes of [010] Fe3C //[112]α (small picture) . 100nm 400nm 500nm Fe3C (a) (b) (c) Residual Stress and Damping Capacity The relationship between the amount of retained austenite and the residual stress was plotted in Figure 3a and between the amount of retained austenite and damping capacity of the strips was plotted in Figure 3b. As can be seen the compressive residual stresses on the top surface of the strips were increased with the increase of the amount of retained austenite in the material. The depth of the compressive residual stresses from the surface was about 0,03 mm. The damping capacity was also increased with increasing retained austenite (Figure 3b). This might be attributed to the increase of the total number of stacking-faults in retained austenite and the boundaries between retained austenite and martensite [5].
RkJQdWJsaXNoZXIy MjM0NDE=