ICF10B

Different from other fatigue behaviours, the loading time of impact fatigue is very short. The specimen at each impact has suffered from very high strain rate. Fatigue-crack initiation results from plastic-deformation accumulation [6] and occurs at sub-surface [3]. The impact fatigue resistance mainly depends on both the strength and plasticity of the material [6]. In this investigation, the influence of the strength on the impact fatigue strength was relatively small. This was consistent with the earlier observations. The impact fatigue strength has shown little dependence on the tensile strength in the range of 1600-2500MPa [3]. One explanation is that the specimen at each impact has withstood very high strain rate, hence the impact fatigue strength should be compared with the tensile properties at high strain rate. On the other hand, the ductility (bendability or elongation) shows a great influence on the impact fatigue strength (Figure 5a). 3.5 4 4.5 5 5.5 6 6.5 7 11 15 1 Bendability Impact fatigue strength (m/s) 9 3 .5 4 4 .5 5 5 .5 6 6 .5 0.34 0.36 0.38 0.4 0.42 0.44 Damping index, b Impact fatigue strength (m/s) Figure 5: (a). Correlation between bendability and impact fatigue strength; (b). Effect of damping capacity on impact fatigue strength. (a) (b) The impact of the specimen from this test was caused by high frequency flexural and torsional vibration [3]. This vibration can be more effectively damped in the steel with high damping capacity. Consequently, the impact stresses will become smaller, and the measured impact fatigue strength will be higher. This is shown in Figure 5b. The above discussion indicates that the improvement of the impact fatigue strength of the valve steel strip can be attributed to the combination of its high strength and high absorption capacity of impact energy (plasticity and damping capacity). As shown in Figure 3a, compressive residual stresses were increased with increasing retained austenite. This may also contribute to the improvement of the impact strength. TABLE 2 DISTRIBUTION OF CRACK INITIATION OF FAILED SPECIMENS FROM EACH VARIANT [%]. Sample Retained austenite (γ’) (vol %) Inclusion Surface and edge Corner Strip A 0,4 73,3 (37%)* 6,7 20 Strip B 4,4 71,4(10%) 14,5 14,3 Strip C 10,1 71,4(10%) 28,6 0 Strip D 14,3 73,4(9%) 20,0 6,7 *: Probability of crack initiation at subsurface inclusion. As known, the fatigue properties are correlated to the tensile strength and the compressive residual stresses in the materials. The results from the pulsating tension fatigue testing were therefore unexpected. Fracture investigation (Table 2) shows that most crack initiations started at inclusions. Increase in retained austenite could not change this distribution (see inclusion in Table 2). On the other hand, it seems that the increase of retained austenite could have facilitated the crack initiations at surface inclusion (comparing with subsurface inclusion) or other surface defects. This is contrary to the conventional phenomena where increase in compressive residual stress on the top surface will lead to crack initiation at subsurface inclusions. One explanation might be that the presence of relatively high amount of retained austenite near the surface

RkJQdWJsaXNoZXIy MjM0NDE=