ICF10B

ORAL REFERENCE: ICF10 0192OR FATIGUE CRACK GROWTH BEHAVIOR OF MICRO-SIZED SPECIMENS PREPARED FROM AMORPHOUS ALLOY THIN FILMS K. Takashima1, Y. Higo1 and M. V. Swain2 1 Precision and Intelligence Laboratory, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama 226-8503, Japan. 2 Faculty of Dentistry and Department of Mechanical & Mechatronic Engineering, The University of Sydney, Australian Technology Park, Everleigh NSW 1430, Australia. ABSTRACT Fatigue crack growth tests have been performed on micro-sized Ni-P amorphous alloy specimens to investigate the size effects on fatigue crack growth behavior of such micro-sized specimens. Two types of cantilever beam type micro-sized specimens with different breadth (10 (B) × 12 (W) × 50 (L) µm3 and 30 (B) × 12 (W) × 50 (L) µm3) were prepared from an electroless plated Ni-P amorphous alloy thin film by focused ion beam machining. Notches with a depth of 3 µm were introduced in the specimens. Fatigue crack growth tests were performed using a newly developed fatigue testing machine for micro-sized specimens in air at room temperature under constant load amplitude and stress ratios of 0.1, 0.3, 0.5 and 0.7. Striations were observed on the fatigue fracture surfaces and fatigue crack propagation rates were estimated by careful measurements of the striation spacings. The fatigue crack growth rates at stress ratios of 0.3 and 0.5 were higher than that at 0.1. This suggests that crack closure may occur even in such micro-sized specimens. The fatigue crack growth resistance is also dependent on the specimen breadth. This suggests that the stress state ahead of the crack may affect the crack growth behavior. The results obtained in this investigation provide basic guidelines for designing actual MEMS devices. KEYWORDS Micro-sized specimen, Fatigue, Crack growth, Amorphous alloy, Thin film, Size effect INTRODUCTION Many micro-sized components are involved in microelectromechanical systems (MEMS) and these components are subjected to cyclic loading as they move. These micro-sized components are usually fabricated from a thin film deposited on a substrate using suitable surface micromachining techniques. The evaluation of fatigue properties for thin films is thus extremely important to design reliable and long-term durable MEMS devices. For example, the components used in micro-optical mirrors and switches are considered to experience extremely high number of cyclic loads (over 108 cycles). To date, fatigue tests for thin films and fatigue life of such films have been investigated [1-3]. However, there

RkJQdWJsaXNoZXIy MjM0NDE=