ICF10B

- measured values of acceleration were up to 0.2 m/s2, what is acceptable, but during the test the crane was driven very carefully – in every day’s use, with the influence of wind, these values can be higher. - it is interesting to notice that the stresses were mostly caused by the manoeuvres of the crane – stresses caused by the loads were not significant. This result could be expected, because the maximum allowable load (250 kN) is less then 10% of the own weight of the construction. FEM ANALYSIS Finite Elements Method was used to determine the global stress distribution and to find out the weak points of construction that could cause high stress gradients and stress concentration. Linear elastic model and 3D- Plate elements with four or three nodes and six degrees of freedom was used. Figure 3: FEM model of the lower part of the crane (Variant with stiffeners) Figure 4: Typical stress distribution – visible areas of stress concentration

RkJQdWJsaXNoZXIy MjM0NDE=