The geometry of the lower part of the crane was defined by 2191 elements (2327 elements in variants with stiffeners) were used, Figure 3. Boundary conditions were defined as follows: - all six degrees of freedom on the nodes at the bottom contour of model were constrained, - concentrated forces and bending moments are distributed along the nodes on the top of the model, representing the own weight of upper part of the crane and particular load case. The complete analysis included 17 variants, with various loads, with or without stiffeners , with different orientation of crane branch and including the weight of construction. Typical results of FEM analysis are shown on Figure 4. REPAIR PROCEDURE Strain gauge measurement and FEM analysis showed the source of crack initiation – high stress concentration in the transition areas from vertical to horizontal part of the supports. At critical points those stresses exceeded the fatigue strength of material and caused the crack initiation and growth. Variable loads cannot be avoided, so the only solution was to redesign the critical areas in order to redistribute the local stresses. FEM analysis also showed the best way for redistribution of high stresses: application of triangle stiffeners that fit the existing construction (Figure 4 and Figure 5). Those stiffeners were welded by using MAG process. The heat treatment was used to minimize the residual stresses and fatigue limit of welds was increased by grinding the weld toes and roots. Figure 5: Positions of attached strain gauges After the repair was completed, stresses at critical points were measured once again and compared to the values predicted by FEM. Places where strain gauges were attached are shown on Figure 5, and the results are shown in Table 1. Presented results are approximate, because the strain gauges cannot be attached perfectly at the same positions. According to data from Table 1., it is clear that the stresses at critical points are significantly lowered, especially in critical areas. All the stresses are under the fatigue limit, so the main source for crack growth is removed.
RkJQdWJsaXNoZXIy MjM0NDE=