design strains are increasing to such a level that fatigue is now a real problem, particularly under compressive loading. To fully understand the fatigue of a material it is necessary to gain an understanding of how damage initiates and accumulates, and how this damage will affect the materials properties. The complexity of composite microstructures means that the wide range of fatigue damage mechanisms are often diffuse throughout the laminate. Another major factor that restricts the understanding of damage initiation during fatigue testing of laminates is the scatter found in fatigue lives. This impedes the effectiveness of carrying out interrupted tests with destructive evaluation, since at a given number of cycles it is impossible to say what percentage of life has passed. There is the possibility of using thermography to overcome this problem and this is investigated here. The work carried out here identifies delaminations as the major damage mechanism. These need further investigation and hence work has begun to investigate the relationship between mixed-mode loading and delamination growth rates using a mixed-mode bending rig. EXPERIMENTAL The material used in the program was a composite system containing high strength continuous 919HF carbon fibres in HTA epoxy resin matrix. Cytec Fiberite supplied this in zero-bleed pre-preg form with a nominal fibre content of 55-wt%. A single stacking sequence was used for all static and fatigue tests. This was a 16-ply laminate with the lay-up [(±45˚, 90˚, 0˚)2]s. This lay-up is a quasi-isotropic lay-up and it gives approximately uniform properties in the plane of the laminate. The composite panels were laid up by hand. The composites were then autoclaved following the manufacture’s specifications. The cured plates were then C-scanned to check for any defects. Any faulty areas were avoided when preparing specimens. The panels were cut into specimens with final dimensions 250 mm or 200 mm long by 20 mm wide, unwaisted. This left a gauge length of either 150 mm or 100 mm for tensile and compressive fatigue tests respectively. The final thickness of the specimens was nominally 2 mm without end tabs and 6 mm with end tabs. The MMB specimens have a balanced lay-up with a 0/45˚ interface at the centre. A PTFE film was used as a starter crack and edge inserts are also used to try and prevent fibre bridging. The specimens were then prepared in the same way as the fatigue specimens. Static tests were conducted using a 100 kN screw machine at a loading rate of 1 to 2 mm per minute to bring failure within 90 seconds. Fatigue tests have been completed using an Instron servo hydraulic machine. Tests have been completed at R ratios 0.1 and 10. These represent a tension-tension and a compression-compression loading case respectively. All fatigue tests have been completed at a rate of 10 Hz. As has already been stated, thermography was used in the fatigue tests at R = 0.1 to investigate damage initiation and growth. To investigate delaminations in more detail mixed-mode bend tests have been carried out using the modified MMB rig designed by Crews et al(2). A schematic diagram is shown in figure 1. Currently only static results are available.
RkJQdWJsaXNoZXIy MjM0NDE=