ICF10B

And a lot of studies have been conducted for applying TiO2 film to anti-bacterium, water decomposing, anti-stain and deodorant coatings[3-5] The TiO2's photo-catalytic effect can be obtained under the condition of UV light illumination as shown in the following equation. H2O + 2h + → 2H+ + (1/2) O2 (1) Purpose of this study is to apply coated TiO2 thin film to the corrosion protecting film of substrate metals using photocurrent obtained from UV ray irradiation. This implies the cathodic protection employing outer electric source. Therefore, even though when the film having defect in itself, the TiO2 thin film shows corrosion protecting effects to substrate without an anodic dissolution of film itself. In this study, formation of TiO2 thin film was conducted on AISI 304 stainless steel by Ion-Beam-Mixing method. Then, the characterization of the compositions and crystal structure of deposited thin films were conducted by XRD and ESCA. And also, cathodic protection performance of TiO2 thin film with some defect distribution in itself was investigated under UV ray irradiation condition. EXPERIMENTAL PROCEDURES The Specimen The specimen used in this study was 0.15 μm thick TiO2 thin film coated on AISI 304 stainless steel plate (25×50 ×1.0mm) by Ion-Beam-Mixing method shown in Figure 1. Because, TiO2 thin film made by Ion-Beam-Mixing method had superior adhesive strength. In this process ion beams of the inert gas of Ar and He have been used for assisting to obtain TiO2 thin film with well-crystallized microstructure. The surface of AISI 304 substrate specimen was finished like mirror, and also degreased by methanol. Table 1 showed condition of TiO2 thin film formation by this method. Chemical compositional profile of thin films was examined by X-ray Photoelectron Spectroscopy and the structure of coated layer was investigated by X-ray Diffraction. Figure 1:The chamber of Ion-Beam-Mixing equipment TABLE 1 CONDITION OF TiO2 FILMS FORMATION BY ION-BEAM-MIXING METHOD Ion beam gas Ar+ He+ Ar or He gas pressure (mPa) 3.0 4.0E-2 O2 gas pressure (mPa) 14.0 18.0 Ar or He ion beam current (μA/cm2) 20.0 15.0 Ti evaporation rate (μm/s) 0.5 0.5 Thickness of films (μm) 0.15 0.15

RkJQdWJsaXNoZXIy MjM0NDE=