Electrochemical Measurement To examine the corrosion characteristics of TiO2 coated specimen, the corrosion potential measurement and the anodic polarization measurement were conducted with and without the UV ray irradiation employing automatic polarization test system shown in Figure 2. For an electrochemical measurement, the specimen was coated by silicone for insulation from solution with non-coated area of 1cm2 left for testing. Each examination was conducted using three electrodes method that composed from specimen (working electrode), Pt (counter electrode) and the saturated calomel electrode (SCE)(referential electrode). Anodic polarization measurement was conducted in 0.3 wt% NaCl aqueous solution of 298K from –700 to 1000mV at a sweep rate of 20mV/min [3]. Natural corrosion potential measurement was conducted initially during 2 hours without UV ray irradiation, next 2 hours with UV illumination and final 2 hours in dark again. The light source was UV ray whose wave lengthλ =366nm and luminous intensity was 1.70mW/cm2. The distance of UV light from specimen was kept to be 60mm during testing. Figure 2:Schematic diagram of the system for electrochemical measurements EXPERIMENTAL RESULTS AND DISCUSSIONS Examination of the Compositions and Crystal Structure of Deposited Thin Films The depth profiles of chemical composition and crystal structure of TiO2 thin film made by Ion-Beam- Mixing method was investigated by XPS. The correlation between the composition ratio O/Ti and etching time was obtained and shown in Figure 3 together with those of other TiO2 films made under different Ar ion 0 1 2 3 4 5 6 1 2 3 Etching time(1.0min/div) Ratio of O/Ti(-) 20μA/cm2 15μA/cm2 5μA/cm2 Figure 3: The composition ratio of TiO2 thin films made under various Ar ion beam current
RkJQdWJsaXNoZXIy MjM0NDE=