ICF10B

ORAL REFERENCE: 100439 FRACTURE IN CHROMIUM: AN ATTEMPT TO IMPROVE DUCTILITY R. Wadsack1, R. Pippan1 and B. Schedler2 1Austrian Academy of Sciences – Erich Schmid Institute of Materials Science, Jahnstrasse 12, 8700 Leoben, Austria 2Plansee AG, 6600 Reutte, Austria ABSTRACT Due to their low neutron-induced radioactivity chromium based materials are considered to be candidates as structure materials in fusion technology. Drawbacks for the application of these materials in industrial design are their brittleness at Room Temperature (RT) and their high Ductile to Brittle Transition Temperatures (DBTT). The investigated specimens (pure chromium with a purity of about 99.97%) have been produced in a powder metallurgical route. They have been tested in the as HIPped (Hot Isostatic Pressed) condition and after different pre-deformations. The as HIPped microstructure shows in bending tests and tension tests brittle behavior at RT and a steep increase of ductility in the temperature range between 200°C and 250°C. Fracture toughness investigations reveal a DBTT between 290°C and 300°C. The KQ value increases from 12 MPa√m at 290°C up to a value exceeding 500 MPa√m at 320°C. Additional to the static fracture toughness investigations also fatigue crack growth tests were performed at RT and above DBTT in order to improve the understanding of the fracture processes. An improvement in ductility and an increase in bending fracture strength have been induced by pre-deformation in tension, in bending, by single passed Equal Channel Angular Extrusion (ECAE) and by die compression. KEYWORDS ECAE, fracture toughness, cleavage fracture, DBTT, fatigue, ductility, chromium INTRODUCTION Due to their low neutron-induced radioactivity chromium based materials are considered to be candidates as structure materials in fusion technology. Drawbacks for the application of these materials in industrial design are their brittleness at Room Temperature (RT) and their high Ductile to Brittle Transition Temperatures (DBTT). In this paper mechanical and fractographical investigations are presented of pure chromium (DUCROPUR) with a purity of about 99.97% (N: 19µg/g, C: 51µg/g, O: 40µg/g, H: 2µg/g). The specimens have been produced in a powder metallurgical route by the company Plansee. The density after Hot Isostatic Pressing (HIP) was 7.165g/cm3 (99.51%) and the grain size was about 100µm. The material has been investigated in the as HIPped condition (recrystallized microstructure) and after different pre-deformations.

RkJQdWJsaXNoZXIy MjM0NDE=