ICF10B

EXPERIMENTAL PROCEDURES Different tests have been performed to characterize the mechanical properties of recrystallized pure chromium (DP-R). Notched and in compression pre-cracked 3-point bending samples (6x6x30mm) have been used to determine the fracture toughness below the DBTT. The span of the rolls was 24mm. Above this temperature J-tests using CT-specimens (W=25mm, B=12mm, a=12mm) have been carried out to measure the value of fracture toughness. To determine the DBTT and the strengths as a function of temperature of uncracked specimens 3-point bending tests (samples 6x6x30mm) and tension tests (samples ∅=3.5mm, l0=17.5mm), have been performed. All samples have been mechanically polished and electropolished to minimize the surface influence. Furthermore some simple compression tests (samples 6x6x12mm) have been done to determine the yield strengths below the DBTT. To improve the understanding of the fracture processes fatigue crack growth tests (CT-specimens W=25mm, B=6mm, a=12mm) have been performed in air at RT and above DBTT. Recrystallized (as hipped) tensile and bending specimens have been plastically deformed above the DBTT. These pre-deformed samples have been tested at RT. The crosshead velocity in the bending tests was 0.08mm/min and the strain rate in the tensile tests was ε& =7.6x10-5s-1. Samples have been pre-deformed by single passed Equal Channel Angular Extrusion (ECAE) [1] at 320°C and by die compression at RT. From these resulting samples small specimens have been machined using a diamond wire saw. Subsequently, they have been heat treated in air for 80 minutes at 300°, 500° and 700°C and tested in bending (ECAE: span of the rolls=16.5mm, die compression: span of the rolls=22.5mm) at RT. RESULTS AND DISCUSSION Tests on recrystallized samples Fracture toughness investigations The obtained fracture toughness values of the performed K- and J-tests are summarized in Tab.1. The specimen size criterion of the ASTM standards was not fulfilled for the toughness values which are marked by a star. TABLE 1 KIC- OR KQ-VALUES OF RECRYSTALLIZED PURE CHROMIUM (DP-R) IN MPA√M T[°C] DP-R -196 3.0 25 7.7 100 11.7* 200 11.6* 280 11.8* 290 17.5* 320 ~500* 480 500*-660* From liquid nitrogen temperature (-196°C) up to 290°C the toughness values increase slightly with increasing temperature. No macroscopic plastic deformation has been observed. The fracture surfaces are characterized by cleavage planes. Above 300°C the fracture behavior changes rapidly and dramatically. The samples show large plastic deformations at the crack tip before fracture (CTOD≈1.4mm). The toughness values calculated from the J-tests are 500 MPa√m at 320°C and between 500 and 660 MPa√m at 485°C. The fracture surface of a sample tested at 485°C is depicted in Fig.1a. Similar to the fracture surface of the specimen tested at 320°C it shows an extensive crack tip blunting. The stable ductile crack propagation has

RkJQdWJsaXNoZXIy MjM0NDE=