been observed only at 485°C. In spite the large toughness values the final fracture occurs again in a cleavage mode. (a) b) SINTERPORE D A B C Figure 1: Fracture surfaces of (a) a J-integral sample tested at 485°C (A...final cleavage fracture, B...stable ductile crack growth, C...blunting zone, D...fatigue pre-crack) and (b) a bending sample tested at RT Bending tests 0 100 200 300 400 500 0 100 200 300 400 500 T C] σf [MPa] / σy [MPa] DP-R "brittle" DP-R "ductile" The obtained results are summarized in Fig. 2. Within the DBTT range (which is here somewhat lower than in the fracture toughness tests) some samples fail in a brittle mode and some show large plastic deflections. Below 200°C no large plastic deflections have been observed. Above DBTT the test has been interrupted after a plastic deflection of about 2mm without final fracture. DBTT- range [° Figure 2: Dependence of bending strengths on temperature; the full symbols indicate fracture strengths (σF), the open symbols indicate “yield strengths” (σy) at the plastic deflection of 0.01mm At RT and at a temperature somewhat smaller than DBTT a Weibull characterization has been performed. The Weibull modulus increases from m=20.7 at RT up to m=59.2 at 175°C. In both tests series the initiation points of fracture are usually sinterpores (Fig.1b). Tension tests The obtained strengths in MPa and strains in % are listed in Tab. 2. σ0.2 is the 0.2% offset yield strength, σUYP the upper yield point and σUTS the ultimate tensile strength. εa is the transversal strain and εl the longitudinal strain which is related to 5 times the sample diameter.
RkJQdWJsaXNoZXIy MjM0NDE=