TABLE 2 TENSILE STRENGTHS IN MPA AND STRAINS IN % T [°C] σ0.2 or σUYP σUTS εa εl 25 319.0 319.0 0.6 200 199.3 195.8 2.9 3.1 300 121.1 244.8 79.8 52.6 400 108.5 249.8 84.7 49.4 600 113.1 219.05 87.9 36.9 800 82.6 151.9 95.3 38.3 960 63.1 85.3 84.729.7 The fracture surfaces of DP-R below DBTT are again characterized by cleavage planes. Somewhat above the DBTT large plastic deformations take place but beside void formation also cleavage planes are observed on the fracture surface (Fig.3a). With increasing temperature the cleavage planes disappear and the void formation increases (Fig.3b). (a) (b) Figure 3: Fracture surfaces of DP-R tensile specimens (a) tested at 300°C and (b) tested at 400°C Compression tests The upper yield point is 402.2MPa and 183.3MPa at RT and 170°C, respectively. At RT the upper yield point is about 25% larger than the fracture stress in tension. In contrast to the tension tests large plastic deformations can be obtained without failure. Fatigue crack growth tests Fatigue crack growth experiments were performed at RT and somewhat above DBTT (300°C). The stepwise increasing load amplitude test [2] on compression pre-cracked specimens was applied, which allows to measure fatigue crack growth behavior between the effective threshold and the long crack threshold. At RT the long crack threshold of stress intensity range (at a stress ratio of 0.1) and fracture toughness are approximately the same. However below the long crack threshold the crack propagates over short distances where the fracture surface showed features of a typical ductile metal. This indicates that a certain plastic deformation of the crack tip is possible also at RT. At 300°C a fatigue crack growth behavior typical for ductile metals was observed. An effective threshold ∆Keff,th≈3.5MPa√m and a long crack threshold ∆Kth≈7.5MPa√m have been determined at a stress ratio of 0.1.
RkJQdWJsaXNoZXIy MjM0NDE=