Tests on pre-deformed samples It had been reported [3-5] that chromium can be ductile at RT. Beside the amount of the interstitial solved impurities (N, C,...) the dislocation density plays an important role. Recrystallized chromium has been found usually brittle at RT whereas pre-deformed samples showed sometimes ductility at RT. Therefore samples have been pre-deformed to investigate the influence of dislocation density on ductility at RT. Pre-deformation in bending and tension Bending samples of DP-R have been plastically pre-deformed at 400°C (deflection about 1mm). After that the samples have been tested at RT. In contrast to the tests with DP-R the pre-deformed samples show ductility at RT. A plastic deflection of about 2 mm is obtained before the final fracture occurs in a brittle mode. Similar to the pre-deformation in bending tension samples of DP-R have been pre-deformed (εpl= 3%, 5% or 10%) at about 300°C. The stress-strain curve indicates a pronounced yield point and an area of “Lüders strain”. This assigns a not negligible amount of interstitial solved impurities. All pre-deformed samples show again ductility at RT. For example a 5% pre-deformed specimen at 300°C exhibits at RT a plastic strain of about 6.5% before the brittle final fracture occurs. Pre-deformation by ECAE A 15x15x30mm block was deformed by ECAE at a temperature of about 320°C. The channel angle was 120° which corresponds to a true strain of φ≈1. After a single passed deformation the samples were heat treated. The obtained fracture strengths σF and fracture bending angles αF are listed in Tab.3. Samples without heat treatment and after heat treatments up to 500°C show again a limited ductile behavior. The initiation points of fracture are mostly sinter defects (Fig.4a). The specimens after a heat treatment at 700°C fail in a completely brittle mode again. All bending fracture strengths are about 2 times larger than those of DP-R. An attempt to improve the ductility will be a multiple passed ECAE above the DBTT (work in progress). The aim is to obtain a finer grain size which is not the case by single passed ECAE. TABLE 3 BENDING STRENGTHS (σF) IN MPA AND FRACTURE BENDING ANGLES (αF) AFTER DIFFERENT HEAT TREATMENTS E C A E DIE COMPRESSION Heat treatment after deformation σF [MPa] αF [ °] σF [MPa] αF [ °] none 768.8 0.4 794.7 0.3 none 1031.3 1.9 761.6 0.2 80 minutes at 300°C 854.4 0.6 878.6 0.2 80 minutes at 300°C 932.1 1.0 80 minutes at 500°C 899.1 0.3 743.7 80 minutes at 500°C 1053.8 1.2 889.0 1.0 80 minutes at 700°C 727.9 0 641.3 0 80 minutes at 700°C 721.5 0 Pre-deformation by die compression A 15x15x30mm block was deformed by die compression at RT (true strain φ≈1) and again heat treated. The obtained fracture strengths σF and fracture bending angles αF are listed in Tab.3, too. Again only the samples after the heat treatment at 700°C show completely brittle fracture behavior. The bending fracture strengths
RkJQdWJsaXNoZXIy MjM0NDE=