and fracture bending angles are smaller than those of the tested samples after a pre-deformation by ECAE. Pre-deforming by die compression at RT have nucleated cracks, these cracks act as fracture initiator (Fig.4b) and hence no large plastic deflections are possible. To avoid this crack nucleation die compression should be applied above the DBTT (this work is in progress, too). (a) (b) NUCLEATED CRACK SINTER DEFECTS Figure 4: Fracture point of initiation after pre-deformation by (a) ECAE and (b) die compression CONCLUSIONS • The investigated pure chromium in its recrystallized condition shows a rapid increase in fracture toughness between 290°C (17.5MPa√m) and 320°C (500 MPa√m). In the latter case the final fracture occurs after a large crack tip blunting in a brittle mode. Bending tests of smooth specimens show no plasticity at RT, above 220°C large plastic deformations are obtained. Fatigue crack growth tests reveal indications of ductility at RT and at 300°C the typical behavior of a ductile metal. • A limited ductility in bending and an increase of the bending fracture strength results after different predeformations. The best results are obtained by small pre-deformations in bending. The pre-deformation by die compression at RT is characterized by nucleation of small cracks. Therefore no larger plastic deformations can be obtained. ACKNOWLEDGEMENTS This work has been carried out within Association EURATOM-ÖAW and is supported by the Bundesministerium für Wissenschaft, Forschung und Kunst. REFERENCES 1. R. Z. Valiev, A. V. Korznikov and R. R. Mulyukov (1993), Mater. Sci. Eng. A168, 141-148 2. R. Pippan, L. Plöchl, F. Klanner, H.P. Stüwe (1994), Journal of Testing and Evaluation 22, 98-103 3. H. L. Wain, A. R. Edwards (1960), Metallwissenschaft und Technik, 387-395 4. H. L.Wain, F. Henderson, S. T. M. Johnstone, N. Louat (1957), J. of the Institute of Metals, 281-288 5. H. L.Wain, F. Henderson, S. T. M. Johnstone (1954), Journal of the Institute of Metals, 133-142
RkJQdWJsaXNoZXIy MjM0NDE=