observed due to different mechanical and thermal properties of filler and bonded components which can influence the total mechanical-thermal reliability strongly. In these systems local defects such as cracks can appear as a result of inhomogeneities, residual stress of material and high thermal and mechanical loading gradients between the different materials. Consequently the methods of fracture mechanics have an increasing significance regarding the assessment of failure behaviour. The aim is the optimisation of toughness for epoxies under extreme loading conditions of practice. The industrial application of fracture mechanics values for this purpose and the evaluation of structures basically depends on the geometry independence of these parameters. Only under the condition of geometryindependent parameters the structures developed have an optimum of reliability and operation safety in practice. Compact-tension (CT)-specimens normally used require much material and are often unsuitable for experimental investigations. In the future, the application of miniature specimens for determination of fracture mechanics parameters should be enabled so that an efficient toughness evaluation of new-developed materials can be performed [2]. EXPERIMENTAL Material The test material chosen for all investigations was epoxy resin Epilox A-1701 from Leuna-Harze GmbH. In accordance to the manufacturer’s instructions the curing was carried out at 160 °C. The resin was used both in the unfilled state and reinforced with silica particles (table 1). The fracture mechanics values of the cured resins were measured by mini-compact-tension-specimens with the dimensions length L = 25.4 mm, width W = 20.4 mm, and thickness B = 1 - 10 mm. For all specimens the ratio of the initial crack length to the width a/W was 0.55. Additionally, to realize a sharpened crack tip, the specimens were notched with an industrial razor blade. TABLE 1 INVESTIGATED MATERIALS Filler Producer Type of filler Diameter Teco Sil 44 L C-E-Minerals Glass powder 9 - 13 µm Sheriglass 5000 Potters Ballotini Glass balls 3.5 - 7 µm Sheriglass 2024 Potters Ballotini Glass balls 100 - 200 µm Test techniques Collecting lens Junction diode Evaluation and documentation CT-specimen Rotating mirror Start Stop Laser Deflecting mirror Beam divisor F F Motor v t k Beam 1. 2. 20.4 25.4 Figure 1: Laser double scanner system and specimen dimensions
RkJQdWJsaXNoZXIy MjM0NDE=