to fatigue crack growth and fracture. Understanding the fatigue crack growth and fracture behavior of NiTi alloys is imperative for applications where the alloys are subjected to a combination of low cycle fatigue (active use of the transformation) and high cycle fatigue (inactive structural support) conditions. Such loading sequences facilitate the formation of microcracks that can lead to premature fracture of the shape memory alloy component. The present study will consider the fracture mechanisms in single crystal Ti-50.8at%Ni with three different Ti3Ni4 precipitate sizes. MATERIALS AND METHODS Ti-50.8at%Ni single crystal specimens were grown from a single material batch using the modified Bridgeman technique in an inert gas atmosphere in the temperature range 1773 K – 1893 K. Following growth, the crystals were homogenized at 1273 K for 24 hours in a vacuum furnace and quenched into ambient temperature water, leaving them in the solutionized state. The solutionized single crystal NiTi materials were given subsequent aging treatments of 1.5 hr @ 723 K, 1.0 hr @ 773 K, and 1.5 hr @ 823 K which resulted in Ti3Ni4 precipitates with sizes of 50 nm, 150 nm, and 400 nm, respectively. Mechanical tests were conducted at room temperature (T = 298 K) in laboratory air conditions. Monotonic and cyclic tests (total strain range of 3%, R = 0) were conducted until complete fracture of the specimens. Monotonic tests were conducted on samples aged 1.0 hr @ 773 K with a [100] loading axis orientation. Cyclic tests on the crystals with a [148] loading axis orientation were conducted on materials aged 1.5 hr @ 723 K and 1.5 hr @ 823 K. Material regions on the fracture surface that failed through overload during the monotonic and cyclic tests were examined with the Scanning Electron Microscope (SEM). FRACTOGRAPHY The overall fracture surfaces of the three fractured NiTi samples are shown in Figure 1. The crystallographic orientations of the tensile axes (the direction out of the paper) are indicated to the right of the images and the heat treatments are indicated above the appropriate fracture surface image. In general, as the Ti3Ni4 precipitate size increases, and the precipitates lose coherency, the fracture surface demonstrates a rougher appearance, indicating a transition to more ductile local fracture mechanisms. In single crystals, the overall orientation of the fracture surface with respect to the applied tensile axis can give insight into the operative fracture mechanisms. The only fracture surface in Figure 1 perpendicular to the applied tensile axis is the sample loaded along the [100] direction. The samples oriented along [148] demonstrated fracture surfaces with a normal misoriented with respect to the tensile axis. Since the specimens loaded along the [100] direction demonstrated fracture surfaces oriented 90 degrees from the tensile axis, it appears that the {100} planes serve as cleavage planes in NiTi. Previous studies on B2 intermetallics have found that both the {100} and {110} planes can act as cleavage planes [3].
RkJQdWJsaXNoZXIy MjM0NDE=