consistent with previous findings on aluminum alloys where peak aged alloys have a lower toughness compared to overaged alloys [4]. In the aluminum alloys, it has been demonstrated that the finer peak aged precipitates facilitate strong localization and rapid crack extension, rather than crack tip blunting through extensive plasticity [4]. We note that the above observations were typical for the samples given the distinctly different aging treatments. (a) (b) Figure 4: SEM image of dimpled fracture from relatively large second phase Ti3Ni4 precipitates on the fracture surfaces of the [148] crystal aged (a) aged 1.5 hr @ 723 K or (b) 1.5 hr @ 823 K. RAMAFICATIONS AND CONCLUSIONS The fracture of aged single crystal Ti-50.8at%Ni shape memory alloys containing Ti3Ni4 precipitates is controlled by cleavage on the {100} planes coupled with void nucleation, growth, and coalescence from the second phase particles. The two mechanisms of material failure act in conjunction with one another and the dominance of one over the other depends on the relative size of the Ti3Ni4 precipitates and the Ni concentration of the matrix. As the average precipitate size increases, the frequency of large dimples near second phase particles also increases. In materials containing semi-coherent Ti3Ni4 precipitates (50 –150 nm), cleavage fracture is distinct and markings appear consistent with markings from traditional intermetallic materials. However, when the Ti3Ni4 precipitates are larger (400 nm) and incoherent, the markings are wavy and the cleavage fracture planes become locally distorted. Based on the above observation, it is asserted that the Ni-rich supersaturated NiTi matrix surrounding the precipitates is more brittle than a pure NiTi matrix. Most drawn wire and bar stock NiTi has a strong fiber texture of the {111} type along the drawing direction. Since the martensitic transformation is triggered at a lower applied tensile stress level as the crystal orientation approaches the [111]-[110] symmetry boundary, such textured polycrystalline alloys are “favorably” oriented for the transformation under tension. Moreover, alloys with such a favorable transformation texture do not have {100} cleavage planes favorably oriented for fracture. Consequently, the well-documented high tensile ductility (along the drawing direction) of bar and wire stock polycrystalline NiTi alloys is partially attributed to the favorable orientation of the transformation coupled with the unfavorable orientation of {100} cleavage planes.
RkJQdWJsaXNoZXIy MjM0NDE=